Subaru Legacy 2003 Service Manual page 383

STARTING/CHARGING SYSTEMS
5) Remove packing A, three planetary gears, pack-
ing B and plate.
NOTE:
Before removal, confirm the inserting location of
packing A.
( C )
( D )
(A) Packing A
(B) Planetary gear
(C) Plate
(D) Packing B
6) Remove shaft assembly and overrunning clutch
as a unit.
NOTE:
Before removal, confirm the following:
• Lever direction
• Internal gear assembly position
( B )
(A) Lever
(B) Shaft ASSY
(C) Overrunning clutch
(D) Internal gear ASSY
7) Remove overrunning clutch from shaft assembly
as follows:
(1) Remove stopper from ring by lightly tapping
the stopper with an appropriate tool (such as a
socket).
( A )
( B )
SC-00152
( A )
( D )
( C )
SC-00153
SC(H4SO)-8
STARTER
(2) Remove ring, stopper and clutch from shaft.
(A) Socket wrench
(B) Ring
(C) Shaft
(D) Stopper
2. BRUSH HOLDER
Slightly open the metal fitting holding the insulating
plate to the brush holder. Remove the insulating
plate.
NOTE:
The brush and spring can be easily removed from
the brush holder at this time.
(A) Brush holder
(B) Insulating plate
(C) Metal fitting
( A )
( B )
( D )
( C )
( B )
( C )
SC-00014
( A )
SC-00154