Subaru Legacy 2003 Service Manual page 351

LUBRICATION
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
4) Lower engine onto front crossmember.
5) Tighten nuts which secure front cushion rubber
onto front crossmember.
Tightening torque:
69 N·m (7.0 kgf-m, 51 ft-lb)
6) Install front and center exhaust pipes.
<Ref. to EX(H4SO)-6, INSTALLATION, Front Ex-
haust Pipe.> or <Ref. to EX(H4SOw/oOBD)-10, IN-
STALLATION, Front Exhaust Pipe.>
7) Install under cover. <Ref. to EI-13, INSTALLA-
TION, Front Under Cover.>
8) Lower the vehicle.
CAUTION:
When lowering vehicle, wire rope must be re-
leased at the same time.
9) Remove lifting device and steel cables.
OIL PAN AND STRAINER
10) Install pitching stopper.
Tightening torque:
LU-00051
11) Install radiator upper brackets.
12) Install air intake duct and air cleaner case.
LU-00030
<Ref. to IN(H4SO)-7, INSTALLATION, Air Intake
Duct.> and <Ref. to IN(H4SO)-6, INSTALLATION,
Air Cleaner Case.>
13) Install front wheels.
14) Connect battery ground cable.
15) Fill engine oil. <Ref. to LU(H4SO)-8, INSPEC-
TION, Engine Oil.>
C: INSPECTION
By visual check make sure oil pan, oil strainer, oil
strainer stay and baffle plate are not damaged.
LU-00028
LU(H4SO)-16
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2 T1
ME-00218
LU-00097
FU-00009