Subaru Legacy 2003 Service Manual page 756

Tightening torque:
32 N·m (3.3 kgf-m, 23.9 ft-lb)
12) Connect the connector to ABS sensor.
13) Install the propeller shaft. <Ref. to DS-14, IN-
STALLATION, Propeller Shaft.>
14) Install the rear exhaust pipe and muffler.
NOTE:
To facilitate the procedure, apply a coat of SUBA-
RU CRC to matching area of the rubber cushions in
advance.
SUBARU CRC (Part No. 004301003)
(1) Install the right and left rubber cushions.
FUEL TANK
(2) Install the front rubber cushion and attach
muffler assembly.
FU-00460
(3) Install the rear exhaust pipe to center ex-
haust pipe.
Tightening torque:
FU-00458
15) Install the front side protector.
Tightening torque:
16) Install the rear wheel.
17) Lower the vehicle.
FU-00456
18) Tighten the wheel nuts to rear wheel.
19) Install the parking brake cable. <Ref. to PB-7,
INSTALLATION, Parking Brake Cable.>
20) Install the console box. <Ref. to EI-34, IN-
STALLATION, Console Box.>
FU(H4SOw/oOBD)-53
FUEL INJECTION (FUEL SYSTEMS)
18 N·m (1.8 kgf-m, 13.0 ft-lb)
18 N·m (1.8 kgf-m, 13.0 ft-lb)
FU-00457
FU-00455
FU-00443