Subaru Legacy 2003 Service Manual page 234

9) Install the torque converter clutch onto drive
plate. (AT vehicles)
(1) Tighten the bolts which hold torque convert-
er clutch to drive plate.
(2) Tighten other bolts while rotating the engine
by using a socket wrench.
NOTE:
Be careful not to drop the bolts into torque convert-
er clutch housing.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
(3) Clog the plug onto service hole.
10) Install the power steering pump on bracket.
(1) Install the power steering tank on bracket.
(2) Install the power steering pump on bracket,
and then tighten the bolts.
Tightening torque:
20.1 N·m (2.05 kgf-m, 14.8 ft-lb)
ENGINE ASSEMBLY
(3) Tighten the bolts which install power steer-
ing pump bracket, and then install the spark plug
cords.
(4) Connect the power steering switch connec-
tor.
ME-00212
(5) Install the front side V-belt, and adjust it.
<Ref. to ME(H4SO)-42, FRONT SIDE BELT, IN-
STALLATION, V-belt.>
(6) Install the resonator chamber.
Tightening torque:
FU-00020
FU-00139
ME(H4SO)-37
33 N·m (3.4 kgf-m, 24.6 ft-lb)
MECHANICAL
ME-00331
FU-00017
ME-00327