Subaru Legacy 2003 Service Manual page 657

DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
ENGINE (DIAGNOSTICS)
6 CHECK INHIBITOR SWITCH GROUND LINE.
Measure resistance of harness between inhibi-
tor switch connector and engine ground.
Connector & terminal
(T7) No. 12 — Engine ground:
Is the measured value less than the specified
value?
7 CHECK INHIBITOR SWITCH.
Measure resistance between inhibitor switch
connector receptacle's terminals in select level
"N" and "P" positions.
Terminal
No. 7 — No. 12:
Is the measured value less than the specified
value?
8 CHECK SELECTOR CABLE CONNECTION.
Is there any fault in selector cable connection
to inhibitor switch?
Step
EN(H4SO)-260
Value
5 Ω
1 Ω
There is a fault.
Yes
Go to step 7. Repair open circuit
in harness
between inhibitor
switch connector
and starter motor
ground line.
NOTE:
In this case, repair
the following:
• Open circuit in
harness between
inhibitor switch
connector and
starter motor
grond line
• Poor contact in
satrter motor con-
nector
• Poor contact in
starter motor
ground
• Starter motor
Go to step 8. Replace inhibitor
switch. <Ref. to
AT-49, Inhibitor
Switch.>
Repair selector Contact SUBARU
cable connection. distributor service.
<Ref. to CS-12,
NOTE:
Select Cable.>
Inspection by DTM
is required,
cause
cause is deteriora-
tion of
parts.
No
be-
probable
multiple