Subaru Legacy 2003 Service Manual page 361

SPEED CONTROL SYSTEMS
• RHD MODEL
9) Remove the grommet from toe board.
NOTE:
From the inside compartment, push the grommet
(A) into hole.
(A) Grommet
10) Pull out the cable from toe board hole.
11) Disconnect the accelerator cable bushing from
accelerator pedal lever.
(A)
(A) Flat tip screwdriver
ACCELERATOR PEDAL
SP-00007
(A)
SP-00008
SP-00009
SP(H4SO)-6
12) Disconnect the accelerator cable stopper from
bracket.
(A) Accelerator cable stopper
13) Separate the accelerator cable and bracket.
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
• If the cable clamp is damaged, replace it with a
new one.
• Never fail to cover the outer cable end with boot.
• Be careful not to kink the accelerator cable.
• For tightening torque, refer to "COMPONENT".
<Ref. to SP(H4SO)-2, COMPONENT, General De-
scription.>
2) After installing the accelerator pedal, adjust the
pedal position. <Ref. to SP(H4SO)-8, ADJUST-
MENT, Accelerator Pedal.>
(A)
SP-00010