Subaru Legacy 2003 Service Manual page 233

MECHANICAL
24) Remove the engine from vehicle.
(1) Slightly raise the engine.
(2) Raise the transmission with garage jack.
(3) Move the engine horizontally until main
shaft is withdrawn from clutch cover.
(4) Slowly move the engine away from engine
compartment.
NOTE:
Be careful not to damage the adjacent parts or
body panels with crankshaft pulley, oil level gauge,
etc.
25) Remove the front cushion rubbers.
B: INSTALLATION
1) Install the front cushion rubbers.
Tightening torque:
34 N·m (3.5 kgf-m, 25.3 ft-lb)
2) Install the engine onto transmission.
(1) Position the engine in engine compartment
and align it with transmission.
NOTE:
Be careful not to damage the adjacent parts or
body panels with crankshaft pulley, oil level gauge,
etc.
(2) Apply a small amount of grease to the spline
of main shaft. (MT vehicles)
ENGINE ASSEMBLY
3) Tighten the bolts which hold upper side of trans-
mission to engine.
Tightening torque:
4) Remove the lifting device and wire ropes.
ME-00214
5) Remove the garage jack.
6) Install the pitching stopper.
Tightening torque:
7) Remove the ST from torque converter clutch
case. (AT vehicles)
ME-00214
NOTE:
Be careful not to drop the ST into torque converter
clutch case when removing ST.
ST 498277200
8) Install the starter. <Ref. to SC(H4SO)-6, Installa-
tion, Starter.>
ME(H4SO)-36
50 N·m (5.1 kgf-m, 36.9 ft-lb)
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
STOPPER SET
ME-00216
ME-00214
T1
ME-00218