Subaru Legacy 2003 Service Manual page 529

Hide thumbs Also See for Legacy 2003:
Table of Contents

Advertisement

DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
ENGINE (DIAGNOSTICS)
6
CHECK HARNESS BETWEEN ECM AND
THROTTLE POSITION SENSOR CONNEC-
TOR.
1) Turn ignition switch to OFF.
2) Disconnect connectors from throttle posi-
tion sensor.
3) Turn ignition switch to ON.
4) Measure voltage between throttle position
sensor connector and engine ground.
Connector & terminal
(E13) No. 4 (+) — Engine ground ( − − − − ):
Does the measured value exceed the spec-
ified value?
7
CHECK HARNESS BETWEEN ECM AND
THROTTLE POSITION SENSOR CONNEC-
TOR.
1) Turn ignition switch to OFF.
2) Measure resistance of harness between
ECM connector and throttle position sensor
connector.
Connector & terminal
(B135) No. 13 — (E13) No. 3:
Is the measured value less than the speci-
fied value?
8
CHECK HARNESS BETWEEN ECM AND
THROTTLE POSITION SENSOR CONNEC-
TOR.
Measure resistance of harness between throt-
tle position sensor connector and engine
ground.
Connector & terminal
(E13) No. 3 — Engine ground:
Does the measured value exceed the specified
value?
9
CHECK POOR CONTACT.
Check poor contact in throttle position sensor
connector.
Is there poor contact in throttle position sensor
connector?
Step
EN(H4SO)-132
Value
4.5 V
1 Ω
1 MΩ
There is poor contact.
Yes
Go to step 7.
Repair harness
and connector.
NOTE:
In this case, repair
the following:
• Open circuit in
harness between
throttle position
sensor and ECM
connector
• Poor contact in
throttle position
sensor connector
• Poor contact in
ECM connector
• Poor contact in
coupling connector
• Poor contact in
joint connector
Go to step 8.
Repair harness
and connector.
NOTE:
In this case, repair
the following:
• Open circuit in
harness between
throttle position
sensor and ECM
connector
• Poor contact in
ECM connector
• Poor contact in
throttle position
sensor connector
• Poor contact in
coupling connector
Go to step 9.
Repair ground
short circuit in har-
ness between
throttle position
sensor and ECM
connector.
Repair poor con-
Replace throttle
tact in throttle posi-
position sensor.
tion sensor
<Ref. to
connector.
FU(H4SO)-30,
Throttle Position
Sensor.>
No

Advertisement

Table of Contents
loading

Table of Contents