Fuel Sub Level Sensor - Subaru Legacy 2003 Service Manual

Hide thumbs Also See for Legacy 2003:

Table of Contents

24.Fuel Sub Level Sensor

• Place "NO FIRE" signs near the working area.

• Be careful not to spill fuel on the floor.

1) Disconnect the ground cable from battery.

2) Lift-up the vehicle.

3) Remove the front side fuel tank cover.

4) Drain fuel from fuel tank. Set a container under

the vehicle, and then remove the drain plug from

FUEL SUB LEVEL SENSOR

5) Tighten the fuel drain plug and install the protec-

tor RH (Front).

Tightening torque:

6) Remove the rear seat.

7) Remove the service hole cover.

8) Disconnect the connector from fuel sub level

FUEL INJECTION (FUEL SYSTEMS)

26 N·m (2.65 kgf-m, 19.2 ft-lb)

18 N·m (1.8 kgf-m, 13.0 ft-lb)

Table of Contents