Subaru Legacy 2003 Service Manual page 955

FUEL INJECTION (FUEL SYSTEMS)
5. Crankshaft Position Sensor
A: REMOVAL
1) Disconnect battery ground cable.
2) Remove air intake chamber.
<Ref. to IN(H6DO)-6, REMOVAL, Air Intake Cham-
ber.>
3) Remove engine harness bracket from intake
manifold.
4) Remove service hole cover.
5) Remove bolt which install crankshaft position
sensor to cylinder block.
CRANKSHAFT POSITION SENSOR
FU-00009
FU-00573
FU-00574
FU(H6DO)-30
6) Remove crankshaft position sensor, and discon-
nect connector from it.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
Tightening torque:
5.0 N·m (0.51 kgf-m, 3.7 ft-lb)
FU-00575
FU-00575
FU-00573