Subaru Legacy 2003 Service Manual page 255

MECHANICAL
(6) Tighten the bolts (o) through (v) in alphabet-
ical sequence.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
( o )
( u )
( v )
( r )
(7) Tighten the bolts (w) through (x) in alphabet-
ical sequence.
Tightening torque:
10 N·m (1.0 kgf-m, 7.2 ft-lb)
( w )
( x )
3) Apply a coat of grease to oil seal lips, and then
install the oil seal (A) on camshaft using ST1 and
ST2.
NOTE:
Use a new oil seal.
ST1 499597000 OIL SEAL GUIDE
ST2 499587500 OIL SEAL INSTALLER
( A )
4) Install the plug using ST.
ST 499587700 CAMSHAFT OIL SEAL IN-
STALLER
5) Adjust the valve clearance. <Ref. to ME(H4SO)-
30, ADJUSTMENT, Valve Clearance.>
( q )
( s )
( t )
( p )
ME-00270
ME-00271
ST1
ST2
ME-00272
CAMSHAFT
6) Install the rocker cover and connect PCV hose.
7) Install the oil level gauge guide. (LH side only)
8) Install the camshaft position sensor support. (LH
side only)
9) Install the tensioner bracket.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
10) Install the belt cover No. 2 (RH).
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
11) Install the belt cover No. 2 (LH).
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
12) Install the crankshaft sprocket. <Ref. to
ME(H4SO)-53,
Sprocket.>
13) Install
ME(H4SO)-51,
Sprocket.>
14) Install the timing belt assembly. <Ref. to
ME(H4SO)-47, INSTALLATION, Timing Belt As-
sembly.>
15) Install the belt cover. <Ref. to ME(H4SO)-45,
INSTALLATION, Belt Cover.>
16) Install
ME(H4SO)-43, INSTALLATION, CRANKSHAFT
PULLEY.>
17) Install the V-belt. <Ref. to ME(H4SO)-42, IN-
STALLATION, V-belt.>
ME(H4SO)-58
INSTALLATION,
the camshaft sprocket.
INSTALLATION,
the crankshaft pulley.
ME-00273
ME-00274
Crankshaft
<Ref. to
Camshaft
<Ref. to