Subaru Legacy 2003 Service Manual page 975

FUEL INJECTION (FUEL SYSTEMS)
21.Fuel
A: OPERATION
1. RELEASING OF FUEL PRESSURE
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
1) Disconnect connector from fuel pump relay.
2) Start the engine and run it until it stalls.
3) After the engine stalls, crank it for five more sec-
onds.
4) Turn ignition switch to OFF.
2. DRAINING FUEL
WARNING:
• Place "NO FIRE" signs near the working area.
• Be careful not to spill fuel on the floor.
1) Set vehicle on the lift.
2) Disconnect battery ground cable.
3) Lift-up the vehicle.
4) Remove front right side fuel tank cover.
FUEL
5) Drain fuel from fuel tank.
Set a container under the vehicle and remove drain
plug from fuel tank.
6) Tighten fuel drain plug and install front right side
tank cover.
Tightening torque:
FU-00431
Tightening torque:
FU-00009
7) Lower the vehicle.
FU-00443
FU(H6DO)-50
26 N·m (2.65 kgf-m, 19.2 ft-lb)
18 N·m (1.8 kgf-m, 13.0 ft-lb)
FU-00444
FU-00444
FU-00443