Subaru Legacy 2003 Service Manual page 840

6. Subaru Select Monitor
A: OPERATION
1. HOW TO USE SUBARU SELECT MONI-
TOR
1) Prepare Subaru Select Monitor kit.
2) Connect diagnosis cable to Subaru Select Mon-
itor.
3) Insert cartridge into Subaru Select Monitor.
4) Connect Subaru Select Monitor to data link con-
nector.
(1) Data link connector (A) located in the lower
portion of the instrument panel (on the driver's
side).
( A )
(2) Connect diagnosis cable to data link con-
nector.
CAUTION:
Do not connect scan tools except for Subaru
Select Monitor.
SUBARU SELECT MONITOR
EN-00038
ST
EN-00039
EN-00710
EN(H4SOw/oOBD)-21
5) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
6) Using Subaru Select Monitor, call up diagnostic
trouble code(s) and various data, then record them.
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE.
Refer to Read Diagnostic Trouble Code for infor-
mation about how to indicate DTC. <Ref. to
EN(H4SOw/oOBD)-24, Read Diagnostic Trouble
Code (DTC).>
3. READ CURRENT DATA SHOWN ON DIS-
PLAY.
1) On the «Main Menu» display screen, select the
{2. Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display
screen, select the {Engine Control System} and
press the [YES] key.
3) Press the [YES] key after displayed the informa-
tion of engine type.
4) On the «Engine Diagnosis» display screen, se-
lect the {1. Current Data Display & Save} and press
the [YES] key.
5) On the «Data Display Menu» display screen, se-
lect the {1. 12 Data Display} and press the [YES]
key.
6) Using the scroll key, move the display screen up
or down until the desired data is shown.
ENGINE (DIAGNOSTICS)
( A )
EN-00040