Subaru Legacy 2003 Service Manual page 797

EXHAUST
B: INSTALLATION
1) Install front exhaust pipe to center exhaust pipe.
NOTE:
Replace gaskets with new ones.
Tightening torque:
30 N·m (3.1 kgf-m, 22.4 ft-lb)
2) Install front and center exhaust pipe assembly to
the vehicle.
3) Temporarily tighten bolt which installs front and
center exhaust pipe assembly to hanger bracket.
4) Tighten nuts which hold front exhaust pipe onto
cylinder heads.
Tightening torque:
30 N·m (3.1 kgf-m, 22.4 ft-lb)
FRONT EXHAUST PIPE
5) Tighten bolts which install front and center ex-
haust pipe assembly to rear exhaust pipe.
Tightening torque:
6) Tighten bolt which holds front and center ex-
haust pipe assembly to hanger bracket.
EX-00050
Tightening torque:
7) Install under cover. <Ref. to EI-13, INSTALLA-
EX-00049
TION, Front Under Cover.>
8) Lower the vehicle.
9) Connect front oxygen sensor connector. (With
catalytic converter)
EX-00102
EX(H4SOw/oOBD)-10
18 N·m (1.8 kgf-m, 13.0 ft-lb)
35 N·m (3.6 kgf-m, 26.0 ft-lb)
FU-00455
EX-00049
EX-00101