Subaru Legacy 2003 Service Manual page 360

2. Accelerator Pedal
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the lock nut from accelerator cable
bracket.
3) Separate the accelerator cable from bracket.
4) Remove the accelerator cable end from throttle
cam.
NOTE:
Be careful not to kink the accelerator cable.
• SOHC MODEL
(A)
(B)
• DOHC turbo MODEL
(D)
(A) Lock nut
(B) Accelerator cable bracket
(C) Accelerator cable
(D) Throttle cam
5) Remove the clip inside engine compartment.
• LHD SOHC MODEL
(E)
(B)
ACCELERATOR PEDAL
(D)
(C)
SP-00003
(C)
(A)
(B)
SP-00004
(A)
(E) (D)
(C)
(E)
SP-00017
• RHD SOHC MODEL
(E)
(E)
(E)
• DOHC turbo MODEL
(B)
(E)
(A) Toe board
(B) Accelerator cable
(C) To accelerator pedal
(D) Brake booster
(E) Clip
6) Remove the instrument panel lower cover from
instrument panel, and connector.
7) Disconnect the connector from kick-down
switch. (AT vehicles)
8) Remove the accelerator pedal connecting bolt
from accelerator pedal bracket.
• LHD MODEL
SP(H4SO)-5
SPEED CONTROL SYSTEMS
(B)
(E)
(D)
(E)
(D)
(C)
(A)
SP-00005
(C)
(A)
SP-00006
SP-00018