Subaru Legacy 2003 Service Manual page 297

Hide thumbs Also See for Legacy 2003:

Table of Contents

B: INSTALLATION

1) Install front exhaust pipe to center exhaust pipe.

Replace gaskets with new ones.

Tightening torque:

30 N·m (3.1 kgf-m, 22.4 ft-lb)

2) Install front and center exhaust pipe assembly to

the vehicle.

3) Temporarily tighten bolt which installs front and

center exhaust pipe assembly to hanger bracket.

4) Tighten nuts which hold front exhaust pipe onto

cylinder heads.

Tightening torque:

30 N·m (3.1 kgf-m, 22.4 ft-lb)

5) Install under cover.<Ref. to EI-13, INSTALLA-

TION, Front Under Cover.>

6) Tighten bolts which install front and center ex-

haust pipe assembly to rear exhaust pipe.

FRONT EXHAUST PIPE

Tightening torque:

7) Tighten bolt which holds front and center ex-

haust pipe assembly to hanger bracket.

Tightening torque:

8) Lower the vehicle.

9) Connect rear oxygen sensor connector.

10) Connect front oxygen (A/F) sensor connector.

18 N·m (1.8 kgf-m, 13.0 ft-lb)

35 N·m (3.6 kgf-m, 26.0 ft-lb)

Chapters

Table of Contents