Subaru Legacy 2003 Service Manual page 392

Hide thumbs Also See for Legacy 2003:

Table of Contents

(3) Remove the nut of terminal B, and then re-

move the rectifier.

To assemble, reverse order of disassembly.

1) Pulling up brush

Before assembling, press the brush down into

brush holder, and then fix them in that position by

passing a [1 mm (0.04 in) dia. length 4 to 5 cm (1.6

to 2.0 in)] wire through the hole shown in the figure.

Be sure to remove the wire after reassembly.

2) Install the ball bearing.

(1) Set the ball bearing on the front cover, and

then securely install an appropriate tool (such as

a fit socket wrench) to the bearing outer race.

(2) Press the ball bearing into the specified po-

sition using a press.

(3) Install the bearing retainer.

3) Press the bearing (rear side) into the rotor shaft

using a press to install.

4) Heat the bearing box in rear cover [50 to 60°C

(122 to 140°F)], and then press the rear bearing

into rear cover.

Grease should not be applied to rear bearing.

Remove the oil completely if it is found on bear-

5) After reassembly, turn the pulley by hand to

check that rotor turns smoothly.

STARTING/CHARGING SYSTEMS

Chapters

Table of Contents