Subaru Legacy 2003 Service Manual page 131

FUEL INJECTION (FUEL SYSTEMS)
Tightening torque:
19 N·m (1.94 kgf-m, 13.7 ft-lb)
8) Tighten the two bolts which install the fuel pipes
on the left side of intake manifold.
Tightening torque:
5.0 N·m (0.51 kgf-m, 3.7 ft-lb)
9) Install the purge control solenoid valve.
Tightening torque:
19 N·m (1.94 kgf-m, 13.7 ft-lb)
10) Connect the hoses to the purge control sole-
noid valve.
INTAKE MANIFOLD
NOTE:
Connect the evaporation hose as shown in the fig-
ure.
FU-00284
11) Install the engine harness onto the intake man-
ifold.
Tightening torque:
12) Connect the connectors to the fuel injectors
and purge control solenoid valve.
13) Hold the engine harness by harness band (A)
and harness bracket (B).
FU-00170
NOTE:
Do not use harness band on harnesses where they
are supposed to be protected by the fuel pipe pro-
tector.
14) Install the fuel pipe protector RH.
FU-00271
Tightening torque:
FU(H4SO)-24
A
(A) To fuel pipe
(B) To intake manifold
16 N·m (1.6 kgf-m, 11.8 ft-lb)
(A)
(A)
(B)
19 N·m (1.9 kgf-m, 13.7 ft-lb)
B
FU-00285
(A)
FU-00517
FU-00267