Subaru Legacy 2003 Service Manual page 390

Hide thumbs Also See for Legacy 2003:

Table of Contents

3) Then insert the tip of a flat tip screwdriver into the

gap between stator core and front cover. Pry them

apart to disassemble.

(A) Screwdriver

4) Hold the rotor with a vise and remove pulley nut.

When holding the rotor with vise, insert alumi-

num plates or wood pieces on the contact sur-

faces of vise to prevent rotor from damage.

(A) Front cover

5) Remove the ball bearing as follows.

STARTING/CHARGING SYSTEMS

(1) Remove the bolt, and then remove the bear-

ing retainer.

(2) Firmly install an appropriate tool (such as a

fit socket wrench) to bearing inner race.

(3) Push the ball bearing off the front cover us-

ing a press.

6) Remove the bearing from rotor using a bearing

7) Unsolder connection between rectifier and stator

coil to remove the stator coil.

Do not allow the 180 — 270 W solding bit to con-

tact the terminals for more than 5 seconds at a

Chapters

Table of Contents