Engine Coolant - Subaru Legacy 2003 Service Manual

COOLING

4. Engine Coolant

A: REPLACEMENT
1. DRAINING OF ENGINE COOLANT
1) Lift-up the vehicle.
2) Remove under cover.
3) Remove drain cock to drain engine coolant into
container.
NOTE:
Remove radiator cap so that engine coolant will
drain faster.
2. FILLING OF ENGINE COOLANT
1) Fill engine coolant into radiator up to filler neck
position.
Engine coolant amount for refill:
2.0 L MT ;
Approx. 7.0 2 (7.4 US qt, 6.2 Imp qt)
2.0 L AT ;
Approx. 6.9 2 (7.3 US qt, 6.1 Imp qt)
2.5 L MT ;
Approx. 6.8 2 (7.2 US qt, 6.0 Imp qt)
2.5 L AT ;
Approx. 6.7 2 (7.1 US qt, 5.9 Imp qt)
CAUTION:
The SUBARU Genuine Coolant containing anti-
freeze and anti-rust agents is especially made
for SUBARU engine, which has an aluminum
crankcase. Always use SUBARU Genuine Cool-
ant, since other coolant may cause corrosion.
ENGINE COOLANT
2) Fill engine coolant into reservoir tank up to upper
level.
3) Attach radiator cap and reservoir tank cap prop-
erly.
4) Warm-up engine completely for more than five
minutes at 2,000 to 3,000 rpm.
LU-00095
5) If engine coolant level drops in radiator, add en-
gine coolant to filler neck position.
6) If engine coolant level drops from upper level of
reservoir tank, add engine coolant to upper level.
7) Attach radiator cap and reservoir tank cap prop-
erly.
CO-00083
CO(H4SO)-14
Full level
FULL
Low level
LOW
CO-00010