Subaru Legacy 2003 Service Manual page 162

(2) Tighten the bolt which holds rear shock ab-
sorber to rear suspension arm. <Ref. to RS-11,
INSTALLATION, Rear Arm.>
Tightening torque:
157 N·m (16 kgf-m, 116 ft-lb)
8) Install the rear brake caliper. <Ref. to BR-29, IN-
STALLATION, Rear Disc Brake Assembly.>
9) Tighten the bolt which holds rear brake hoses
holding bracket.
Tightening torque:
33 N·m (3.4 kgf-m, 25 ft-lb)
10) Install the parking brake cable to cabin by forc-
ibly pushing it forward.
11) Tighten the bolts which hold parking brake ca-
ble holding bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
FUEL TANK
Tightening torque:
12) Connect the connector to ABS sensor.
FU-00463
13) Install the propeller shaft. <Ref. to DS-15, IN-
STALLATION, Propeller Shaft.>
14) Install the rear exhaust pipe and muffler.
NOTE:
To facilitate the procedure, apply a coat of SUBA-
RU CRC to matching area of the rubber cushions in
advance.
FU-00461
SUBARU CRC (Part No. 004301003)
(1) Install the right and left rubber cushions.
FU-00459
FU(H4SO)-55
FUEL INJECTION (FUEL SYSTEMS)
32 N·m (3.3 kgf-m, 23.9 ft-lb)
FU-00460
FU-00458
FU-00456