Fuel Pump - Subaru Legacy 2003 Service Manual

Hide thumbs Also See for Legacy 2003:

Table of Contents

FUEL INJECTION (FUEL SYSTEMS)

22.Fuel Pump

• Place "NO FIRE" signs near the working area.

• Be careful not to spill fuel on the floor.

The fuel pump assembly consists of fuel pump and

fuel level sensor.

1) Release the fuel pressure. <Ref. to FU(H4SO)-

48, RELEASING OF FUEL PRESSURE, OPERA-

TION, Fuel.>

2) Open the fuel filler flap lid, and then remove the

fuel filler cap.

3) Disconnect the ground cable from battery.

4) Lift-up the vehicle.

5) Remove the protector RH (Front).

6) Drain the fuel from fuel tank. Set a container un-

der the vehicle, and then remove the drain plug

from fuel tank.

7) Tighten the fuel drain plug, and then install the

protector RH (Front).

Tightening torque:

8) Raise the rear seat, and then turn the floor mat

9) Remove the access hole lid.

10) Disconnect the connector from fuel pump.

26 N·m (2.65 kgf-m, 19.2 ft-lb)

18 N·m (1.8 kgf-m, 13.0 ft-lb)

Table of Contents