Mazda RX-8 Manual page 2252

checker) or apply 2-ohm resistance to passenger-side
curtain air bag module connector terminals A and B.
Set the resistance of the SST (Fuel and thermometer
•
checker) to the 2-ohm position.
Connect the negative battery cable.
•
Turn the ignition switch to the ON position.
•
Using the WDS or equivalent, verify the following
•
PID/DATA monitor.
(See PID/DATA MONITOR TABLE .)
OD_P_CURT
Are related wiring harnesses normal?
•
INSPECT SAS CONTROL MODULE
Turn the ignition switch to the LOCK position.
•
Disconnect the negative battery cable and wait for 1
•
min or more .
4
Connect the passenger-side curtain air bag module
•
connector.
Are DTCs B2777, B2778, B2779 and/or B2780
•
indicated?
Replace the air bag wiring harness,
No
then go to the next step.
[Present malfunction diagnosis]
Replace the SAS control
•
module.
(See SAS CONTROL
MODULE
Yes REMOVAL/INSTALLATIO
N .)
[Past malfunction diagnosis]
DTC troubleshooting
•
completed.
No DTC troubleshooting completed.
(w) RX-8 Safety
Page 91