Mazda RX-8 Manual page 2274

Hide thumbs Also See for RX-8:

Table of Contents

If the SAS control module is replaced, turn the ignition switch to the ON position for 20 s or

more after completing the configuration.

8. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.

If the air bag system warning light does not operate normally, refer to the on-board diagnostic

system (air bag system) and perform inspection of the system.

SAS CONTROL MODULE CONFIGURATION

1. Connect the WDS or equivalent to the DLC-2 (16-pin).

2. Select "Module programming" from the menu.

3. Select "Programmable Module Installation".

4. Select the following items and perform procedure according to the directions on the WDS screen.

Troubleshooting