VERIFY WHETHER MALFUNCTION IS IN
PASSENGER-SIDE AIR BAG MODULE (INFLATOR
NO.1) OR RELATED WIRING HARNESS
Connect the leads of the SST (Fuel and thermometer
•
checker) or apply 2-ohm resistance to passenger-
side air bag module (inflator No.1) connector
terminals A and B, and passenger-side air bag
module (inflator No.2) connector terminals A and B.
Set the resistance of the SST (Fuel and thermometer
•
3
checker) to the 2-ohm position.
Connect the negative battery cable.
•
Turn the ignition switch to the ON position.
•
Using the WDS or equivalent, verify the following
•
PID/DATA monitor.
(See PID/DATA MONITOR TABLE .)
OD_PAB1ST
Are related wiring harnesses normal?
•
INSPECT SAS CONTROL MODULE
Turn the ignition switch to the LOCK position.
•
Disconnect the negative battery cable and wait for 1
•
min or more .
4
Connect the passenger-side air bag module
•
connector.
Are DTCs B1913, B1925, B1933 and/or B1935
•
indicated?
Replace the passenger-side air bag
module.
Yes
(See PASSENGER-SIDE AIR BAG
MODULE
REMOVAL/INSTALLATION .)
Replace the air bag wiring harness,
No
then go to the next step.
[Present malfunction diagnosis]
Replace the SAS control
•
module.
(See SAS CONTROL
MODULE
Yes
REMOVAL/INSTALLATIO
N .)
[Past malfunction diagnosis]
DTC troubleshooting
•
completed.
No DTC troubleshooting completed.
(w)
RX-8 Safety
Page 53