Mechanical System Test - Mazda RX-8 Manual

MECHANICAL SYSTEM TEST

Mechanical System Test Preparation
1. Engage the parking brake and use wheel chocks at the front and rear of the wheels.
2. Inspect the engine coolant level. (See ENGINE COOLANT LEVEL INSPECTION .)
3. Inspect the engine oil level. (See ENGINE OIL LEVEL INSPECTION .)
4. Inspect the ATF level. (See Automatic Transmission Fluid (ATF) Level Inspection .)
5. Inspect the idle speed and ignition timing in the P position. (See ENGINE TUNE-UP .)
6. Wait until the engine and transmission reach normal operating temperature.
Line Pressure Test
1. Perform mechanical system test preparation. (See Mechanical System Test Preparation .)
WARNING:
Removing the square head plug when the ATF is hot can be dangerous. Hot ATF can come out
•
of the opening and badly burn you. Before removing the square head plug, allow the ATF to
cool.
2. Connect the SSTs (49 HD64 406A, 49 0378 400B) to the line pressure inspection port and replace the
gauge of the SST (49 0378 400B) with the SST (49 B019 901B).
3. Start the engine and warm it up until the ATF reaches 60    70 ° ° ° ° C {140    158 ° ° ° ° F} .
4. Shift the selector lever to the D range.
5. Read the line pressure while the engine is idling for the D range.
6. Read the line pressure while the engine is idling for the P, R, N positions and M range in the same
manner as in Steps 45.
7. Stop the engine, then replace the SST (49 B019 901B) with the gauge of the SST (49 0378 400B).
8. Start the engine.
(w) RX-8 Transmission (Manual & Auto)
Page 39