Service Management Tasks - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
...
----------------------------------------------
*A:ALA-3>config>service#

5.9 Service Management Tasks

This section discusses the following service management tasks:
•
•
•
•
•
•
•
5.9.1
You can change existing service and SAP parameters after the service or SAP is
created. The changes are applied immediately.
Some v-VPLS or m-VPLS parameters cannot be modified as long as the v-VPLS or
m-VPLS exists. In order to change these parameters, you must remove the service
and reconfigure with the new values. This includes the following service parameters:
•
•
•
For some changes, the admin state of the service or SAP must be set down. If the
admin state is set down, then the operational state of the associated port shall go
down and the state change shall propagate If an SAP is operationally down, no traffic
shall be passed in control and data plane in the SAP and the corresponding
forwarding database entries shall be flushed.
The following displays a modified m-VPLS configuration.
*A:ALA-1>configure>service>vpls# info
----------------------------------------------
description "This is a different description."
Issue: 13
exit
spoke-sdp 2:22 create
exit
mesh-sdp 5:750 create
exit
mesh-sdp 7:750 create
exit
no shutdown
exit
Modifying VPLS Service and SAP Parameters
Enabling and Disabling VPLS Entities
Deleting a VPLS Service or SAP
Showing VPLS information
Clearing VPLS operational data
Showing VPLS SAP operational data
Clearing SAP statistics
Modifying VPLS Service and SAP Parameters
service id
customer ID
VLAN ID
3HH-11985-AAAA-TQZZA
Virtual Private LAN Service
217