Eth-Cfm; Mep; Table 76 Eth-Cfm Command; Table 77 Mep Command - Nokia 7302 Manual

Virtual Leased Line Services
(2 of 2)
4.6.5.10
Table 76
4.6.5.11
Table 77
(1 of 2)
138
Item Description
Description This command specifies an explicit dot1q value used when encapsulating to the SDP far end.
When signaling is enabled between the near and far end, the configured dot1q tag can be
overridden by a received TLV specifying the dot1q value expected by the far end. This signaled
value must be stored as the remote signaled dot1q value for the binding. The provisioned local
dot1q tag must be stored as the administrative dot1q value for the binding.
When the dot1q tag is not defined, the default value of zero is stored as the administrative
dot1q value. Setting the value to zero is equivalent to not specifying the value.
The no form of this command disables the command
Default No vlan-vc-tag
Parameters 0..4094 — Specifies a valid VLAN identifier to bind an 802.1Q VLAN tag ID.

eth-cfm

eth-cfm command
Item Description
Syntax eth-cfm
Context configure>service>epipe>spoke-sdp
Description This command enables the context to configure 802.1ag CFM parameters.

mep

mep command
Item Description
Syntax mep mep-id domain md-index association ma-index [direction {up | down}]
mep mep-id domain md-index association ma-index
Context configure>service>epipe>spoke-sdp>eth-cfm
Description This command enables the configuration of a Ethernet CFM Maintenance Endpoint.
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13