Virtual Private Routed Network Service
7.10.8.8
Table 491
7.10.8.9
Table 492
496
source
source command
Item
Description
Syntax
source ip-address
no source
Context
configure>service>interface>vprn>sap>gre-tunnel
Description
This command sets the source IPv4 address of GRE encapsulated packets associated with a
particular GRE tunnel. It must be an address in the subnet of the associated public tunnel SAP
interface. The GRE tunnel does not come up until a valid source address is configured.
The no form of this command deletes the source address from the GRE tunnel configuration.
The tunnel must be administratively shutdown before issuing the no source command.
Parameters
ip-address — Specifies the source IPv4 address of the GRE tunnel.
Values 1.0.0.0 — 223.255.255.255
remote-ip
remote-ip command
Item
Description
Syntax
remote-ip ip-address
no remote-ip
Context
configure>service>interface>vprn>sap>gre-tunnel
Description
This command sets the primary destination IPv4 address of GRE encapsulated packets
associated with a particular GRE tunnel. If this address is reachable in the delivery service
(there is a route) then this is the destination IPv4 address of GRE encapsulated packets sent
by the delivery service.
The no form of this command deletes the destination address from the GRE tunnel
configuration.
Parameters
ip-address — Specifies the destination IPv4 address of the GRE tunnel.
Values 1.0.0.0 — 223.255.255.255
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13