FD 100/320Gbps NT and FX NT IHub Services Guide
5.16.2.52
Table 177
5.16.2.53
Table 178
(1 of 2)
Issue: 13
prefix
prefix command
Item
Description
Syntax
prefix low-order-vsi-id
no prefix
Context
configure>service>vpls>bgp-ad>vsi-id
Description
This command specifies the low-order 4 bytes used to compose the Virtual Switch Instance
Identifier (VSI-ID) to use for NLRI in BGP auto-discovery in this VPLS service. If no value is
set, the system IP address will be used.
Default
no prefix
Parameters
low-order-vsi-id — Specifies a unique VSI ID.
Values
0..4294967295
route-distinguisher
route-distinguisher command
Item
Description
Syntax
route-distinguisher ip-addr.comm-val | as-number:ext-comm-val
no route-distinguisher
Context
configure>service>vpls>bgp
Description
This command configures the Route Distinguisher (RD) component that will be signaled in the
MPBGP NLRI for L2VPN AFI. This value will be used for BGP-AD and BGP VPLS NLRI if these
features are configured.
If this command is not configured, the RD is automatically built using the BGP-AD VPLS ID.
The following rules apply:
•
If BGP AD VPLS-id is not configured and no RD is configured under BGP node,
RD=VPLS-ID
•
If BGP AD VPLS-id is not configured, an RD value must be configured under BGP node
(this is the case when only BGP VPLS is configured).
•
If BGP AD VPLS-id is configured and an RD value is also configured under BGP node, the
configured RD value prevails.
Values and format (6 bytes, other 2 bytes of type) will be automatically generated.
Default
no route-distinguisher
Parameters
ip-addr:comm-val — Specifies the IP address.
OR
as-number:ext-comm-val — Specifies the AS number.
3HH-11985-AAAA-TQZZA
Virtual Private LAN Service
281