Table 552 Passive Command; Table 553 Priority Command; Passive - Nokia 7302 Manual

Intelligent services access manager/fttn/fx, fd 100/320gbps nt and fx nt ihub services
Hide thumbs Also See for 7302:
Table of Contents

Advertisement

FD 100/320Gbps NT and FX NT IHub Services Guide
(2 of 2)
7.10.10.15
Table 552
7.10.10.16
Table 553
(1 of 2)
Issue: 13
Item
Description
Description
This command configures the OSPF packet size used on this interface. If this parameter is not
configured OSPF derives the MTU value from the MTU configured (default or explicitly) in the
following contexts:
configure>port>ethernet
If this parameter is configured, the smaller value between the value configured here and the
MTU configured (default or explicitly) in an above-mentioned context is used.
To determine the actual packet size add 14 bytes for an Ethernet packet and 18 bytes for a
tagged Ethernet packet to the size of the OSPF (IP) packet MTU configured in this command.
Use the no form of this command to revert to default.
Default
no mtu — Uses the value derived from the MTU configured in the configure>port context.
Parameters
bytes — The MTU to be used by OSPF for this logical interface in bytes.
Values: 512 — 9198 (9212-14) (Depends on the physical media)

passive

passive command
Item
Description
Syntax
[no] passive
Context
configure>service>vprn>ospf>area>interface
Description
This command adds the passive property to the OSPF interface where passive interfaces are
advertised as OSPF interfaces but do not run the OSPF protocol.
By default, only interface addresses that are configured for OSPF will be advertised as OSPF
interfaces. The passive parameter allows an interface to be advertised as an OSPF interface
without running the OSPF protocol.
While in passive mode, the interface will ignore ingress OSPF protocol packets and not
transmit any OSPF protocol packets.
The no form of the command removes the passive property from the OSPF interface.
Default
Service interfaces defined in configure>router>service-prefix are passive.
All other interfaces are not passive.
priority
priority command
Item
Description
Syntax
priority number
no priority
3HH-11985-AAAA-TQZZA
Virtual Private Routed Network Service
529

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

73307360

Table of Contents