Table 594 Sap-Using Command; Show Commands - Nokia 7302 Manual

Virtual Private Routed Network Service
(2 of 2)
7.10.12
7.10.12.1
Table 594
(1 of 2)
552
Item Description
Description This command creates a context for configuring a RIP neighbor interface.
By default, interfaces are not activated in any interior gateway protocol such as RIP unless
explicitly configured.
The no form of the command deletes the RIP interface configuration for this interface. The
shutdown command in the configure>router>rip>group group-name>neighbor
ip-int-name context can be used to disable an interface without removing the configuration for
the interface.
Default no neighbor — No RIP interfaces defined
Parameters ip-int-name — The IP interface name. Interface names must be unique within the group of
defined IP interfaces for configure router interface and configure service vprn interface
commands. An interface name cannot be in the form of an IP address. Interface names can
be any string up to 32 characters long composed of printable, 7-bit ASCII characters. If the
string contains special characters (#, $, spaces, etc.), the entire string must be enclosed within
double quotes.
If the IP interface name does not exist or does not have an IP address configured an error
message will be returned.

Show Commands

sap-using
sap-using command
Item Description
Syntax sap-using [sap sap-id]
sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
Context show>service
Description Displays SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13