Table 367 Local-Proxy-Nd Command - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
(2 of 2)
6.10.7.16
Table 367
Issue: 13
Item Description
Description This command configures the rate for ICMP host and network destination unreachable
messages issued on the router interface.
The unreachables command enables the generation of ICMP destination unreachables on
the router interface. The rate at which ICMP unreachables is issued can be controlled with the
optional number and time parameters by indicating the maximum number of destination
unreachable messages which can be issued on the interface for a given time interval.
By default, generation of ICMP destination unreachable messages is enabled at a maximum
rate of 10 per 60 second time interval.
The no form of this command disables the generation of icmp destination unreachable
messages on the router interface.
Default unreachables 100 10
Parameters number — The maximum number of ICMP unreachable messages to send. This parameter
must be specified with the seconds parameter.
Values: 10 — 1000
seconds — The time frame in seconds used to limit the number of ICMP unreachable
messages that can be issued.
Values: 1 — 60
local-proxy-nd
local-proxy-nd command
Item Description
Syntax [no]local-proxy-nd
Context configure>service>ies>interface>ipv6
Description This command enables or disables neighbor discovery on the interface.
When enabled, the ISAM will behave as follows:
•
Respond to all neighbor solicitation messages received on the IP interface for IPv6
addresses in the subnet(s) with the system MAC address as link layer address, provided
the link layer address of the destination/target IP address was learned and thus available
in the ISAM's neighbor cache.
•
Forward IPv6 traffic between hosts in the subnet(s) of the IP interface.
•
Drop IPv6 traffic between hosts if the link layer address information for the IPv6 destination
has not been learned.
3HH-11985-AAAA-TQZZA
Internet Enhanced Service
393