Table 554 Retransmit-Interval Command; Retransmit-Interval - Nokia 7302 Manual

Virtual Private Routed Network Service
(2 of 2)
7.10.10.17
Table 554
530
Item Description
Context configure>service>vprn>ospf>area>interface
Description This command configures the priority of the OSPF interface that is used an election of the
designated router on on the subnet.
This parameter is only used if the interface is of type broadcast. The router with the highest
priority interface becomes the designated router. A router with priority 0 is not eligible to be
Designated Router or Backup Designated Router.
The no form of the command reverts the interface priority to the default value.
Default priority 1
Parameters number — The interface priority expressed as a decimal integer. A value of 0 indicates the
router is not eligible to be the Designated Router of Backup Designated Router on the interface
subnet.
Values: 0 — 255

retransmit-interval

retransmit-interval command
Item Description
Syntax retransmit-interval seconds
no retransmit-interval
Context configure>service>vprn>ospf>area>interface
Description This command specifies the length of time, in seconds, that OSPF will wait before
retransmitting an unacknowledged link state advertisement (LSA) to an OSPF neighbor.
The value should be longer than the expected round trip delay between any two routers on the
attached network. Once the retransmit-interval expires and no acknowledgement has been
received, the LSA will be retransmitted.
The no form of this command reverts to the default interval.
Default retransmit-interval 5
Parameters seconds — The retransmit interval in seconds expressed as a decimal integer.
Values: 1 — 1800
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13