Configuring A Vprn Interface - Sap - Nokia 7302 Manual

Virtual Private Routed Network Service
...
----------------------------------------------
*A:ALA-1>configure>service#
7.7.8
To associate an IP interface to one or more network ports and/or access/hybrid ports,
at least two v-VPLS must be configured, one with a SAP on each associated
network/hybrid port, and one with the access/hybrid ports.
After creating the IP interface, an SAP must be created on the Virtual Port P1 for this
IP interface. Such an SAP is called "L3 SAP".
The VLAN ID of the L3 SAP must be equal to the VLAN ID of the v-VPLS.
CLI syntax:
configure service vprn service-id interface ip-int-name sap [sap-id]
Filter policies are configured in the configure>filter context and must be explicitly
applied to a SAP. There are no default filter policies.
Refer to
For more information on the configuration of filters, see the "FD 100/320Gbps NT and
FX NT IHub Router Configuration and Protocols Guide", chapter "Filter Policies".
7.8 Service Management Tasks
This section discusses the following service management tasks:
7.8.1
Use the CLI syntax to modify VPRN parameters (see
Reference").
The following example displays the VPRN service creation output:
*A:ALA-1>configure>service# info
----------------------------------------------
...
vprn 1 customer 1 create
434
static-route 6.5.0.0/24 next-hop 10.1.1.2
no shutdown
exit

Configuring a VPRN Interface - SAP

"Interface SAP Commands"
Modifying VPRN Service Parameters
shutdown
vrf-import "vrfImpPolCust1"
vrf-export "vrfExpPolCust1"
ecmp 2
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
for CLI commands and syntax.
"VPRN Services CLI Command
Issue: 13