Vll Global Commands; Epipe; Table 53 Epipe Command - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
(2 of 2)
4.6.2
4.6.2.1
Table 53
(1 of 2)
Issue: 13
Item Description
Context configure>service>epipe
configure>service>epipe>sap
Description This command creates a text description stored in the configuration file for a configuration
context.
The description command associates a text string with a configuration context to help identify
the content in the configuration file.
The no form of this command removes the string from the configuration.
Default No description associated with the configuration context.
Parameters description-string — The description character string. Allowed values are any string up to 160
characters long composed of printable, 7-bit ASCII characters. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.

VLL Global Commands

epipe

epipe command
Item Description
Syntax epipe service-id customer customer-id
epipe service-id
no epipe service-id
Context configure>service
Description This command configures an epipe service instance. This command is used to configure a
point-to-point epipe service. An epipe connects two endpoints defined as Service Access
Points (SAPs). Both SAPs are defined in separate edge node devices connected over the
service provider network. The far end SAP is generalized into a Service Distribution Point
(SDP). This SDP describes a destination node and the encapsulation method used to reach it.
No MAC learning or filtering is provided on an epipe.
When a service is created, the customer keyword and customer-id must be specified and
associates the service with a customer. The customer-id must already exist having been
created using the customer command in the service context. Once a service has been created
with a customer association, it is not possible to edit the customer association. The service
must be deleted and recreated with a new customer association.
Once a service is created, the use of the customercustomer-id is optional for navigating into
the service configuration context. Attempting to edit a service with the incorrect customer-id
specified will result in an error.
By default, no epipe services exist until they are explicitly created with this command.
The no form of this command deletes the epipe service instance with the specified service-id.
The service cannot be deleted until the service has been shutdown.
3HH-11985-AAAA-TQZZA
Virtual Leased Line Services
125