Bgw320-505 Service Leds; Table 5 Bgw320-505 Service Led Indications - Nokia 7368 ISAM ONT BGW320-505 Product Manual

BGW320-505 unit data sheet
(2 of 2)

3.5 BGW320-505 service LEDs

The front of the BGW320-505 functions as a multi-color service LED indicator. The
LED color and pulse rate acts as a signal to the user, which indicates the state of the
BGW320 and the quality of its backhaul link.
Table
Table 5
(1 of 2)
28
Release 06.02.00b | October 2019 | Edition 01
Connection Description
Reset button Pressing the Reset button for less than 10 seconds reboots the ONT; pressing the
Reset button for 10 seconds resets the ONT to its factory defaults.
Phone This connection is provided through one RJ-14 POTS port.
(POTS)
Power input This connection is provided through a power cable with a Delta Electronics
EPS48R0-16 2-pin connector.
Use only power adapters supplied by AT&T. The use of any non-approved power
adapter may cause damage to persons or equipment. Make sure that all power cord
connectors are securely and completely plugged into receptacles.
Do not use the power adapter in an outdoor environment or any wet locations. Protect
the power adapter from liquids. The conditions above may cause fire, short circuit,
electrocution or shock injury.
USB This connection is provided through one USB 2.0 Type A port.
The voltage rate is 5V.
SFP This connection is provided through a SFP+ cage that uses an optical fiber cable. One
SFP+ connection is supported.
WPS button Located on the front of the ONT, the Wi-Fi Protected Setup button enables and disables
WLAN data encryption.
Supports 802.11ac, 802.11g, 802.11n, and 802.11ax.
5 provides the service LED descriptions for the BGW320-505.
BGW320-505 service LED indications
LED color LED behavior
Off Off
White White solid
White flashing (Slow)
White flashing (Fast)
Orange Orange flashing
3FE-47753-AAAA-TCZZA
7368 ISAM ONT BGW320-505 Product Guide
LED behavior description
Power off
IP service is established
Attempting a broadband connection; for example, the DSL is
attempting to synchronize for the DSL.
Attempting an IEEE 802.1X authentication, or trying to obtain
DHCP information.
A software upgrade is in progress.
A Power-On Self-Test (POST) is in progress.
Issue: 01