Table 181 Split-Horizon-Group Command; Table 182 Vc-Type Command; Split-Horizon-Group - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
5.16.2.56
Table 181
5.16.2.57
Table 182
Issue: 13

split-horizon-group

split-horizon-group command
Item Description
Syntax [no] split-horizon-group [group-name]
Context config>service>pw-template
Description This command creates a new split horizon group (SHG).
Auto-discovered SDP will forward the traffic between the SDPs by default. If mesh kind of
behavior is required, split horizon group needs to be configured.
If split horizon group is configured, auto SDP will not forward the traffic between them.
The no form of the command removes the group name from the configuration.
Parameters group-name — Specifies the name of the split horizon group to which the SDP belongs.
Values A split horizon group is by default not created in a pw-template.
vc-type
vc-type command
Item Description
Syntax vc-type {ether | vlan}
Context config>service>pw-template
Description This command overrides the default VC type signaled for the binding to the far end SDP. The
VC type is a 15 bit-quantity containing a value which represents the type of VC. The actual
signaling of the VC type depends on the signaling parameter defined for the SDP. If signaling
is disabled, the vctype command can still be used to define the dot1q value expected by the
far-end provider equipment.
A change of the bindings VC type causes the binding to signal the new VC type to the far end
when signaling is enabled.
VC types are derived according to IETF draft-martini-l2circuit-trans-mpls.
•
The VC type value for Ethernet is 0x0005.
•
The VC type value for an Ethernet VLAN 0x0004.
Parameters ether — Defines the VC type as Ethernet. The ethernet and vlan keywords are mutually
exclusive. When the VC type is not defined, the default is Ethernet for spoke SDP bindings.
Defining Ethernet is the same as executing no vc-type and restores the default VC type for
the spoke SDP binding (hex 5).
vlan — Defines the VC type as VLAN. The ethernet and vlan keywords are mutually
exclusive. When the VC type is not defined, the default is Ethernet for spoke SDP bindings.
3HH-11985-AAAA-TQZZA
Virtual Private LAN Service
283