Configuring An Sdp; Sdp Configuration Tasks - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
-------------------------------------------
...
-------------------------------------------
A:A:ALA-12>configure>service#
3.8.3
The most basic SDP must have the following:
•
•
•
3.8.3.1
This section provides a brief overview of the tasks that must be performed to
configure SDPs and provides the CLI commands.
Consider the following SDP characteristics:
•
•
•
•
•
•
•
To configure a basic SDP, perform the following steps:
1 Specify an originating node.
2 Create an SDP ID.
Issue: 13
customer 5 create
description "Nokia Customer"
contact "Technical Support"
...

Configuring an SDP

A locally unique SDP identification (ID) number.
The system IP address of the originating PE and the far-end PE.
An SDP encapsulation type =MPLS.

SDP Configuration Tasks

SDPs can only be created with encapsulation type MPLS.
Each distributed service must have an SDP defined for every remote PE to
provide VLL, VPLS, and VPRN services.
A distributed service must be bound to an SDP. By default, no SDP is associated
with a service. Once an SDP is created, services can be associated to that SDP.
An SDP is not specific or exclusive to any one service or any type of service. An
SDP can have more than one service bound to it.
The SDP IP address must be a peer PE system IP address.
In order to configure an MPLS SDP, LSPs must be configured first and then the
LSP-to- SDP association must be explicitly created.
In the SDP configuration, automatic ingress and egress labeling (targeted LDP) is
enabled by default. Ingress VC labels and egress VC labels are signaled over a
TLDP connection between two PEs.
Note that if signaling is disabled for an SDP, then services using that SDP must
configure ingress vc-labels and egress vc-labels manually.
3HH-11985-AAAA-TQZZA
Services Overview
55