Duplex Nt Erps Performance Considerations; Support Service And Solution Combinations; Configuration Guide-Lines - Nokia 7302 Manual

Intelligent services access manager/fttn/fx, fd 100/320gbps nt and fx nt ihub services
Hide thumbs Also See for 7302:
Table of Contents

Advertisement

FD 100/320Gbps NT and FX NT IHub Services Guide
3.11.5
This section suggests actions to be performed by the operator to optimize
performance impacts in the event of Active-NT switchover on a Duplex
Load-Balanced NT.
Handling NT Switchover Scenario in a Load-balanced Duplex NT:
In case if Multi NT lags are not used, and each ERPS path is on different NT:
3.11.6
The Ethernet rings are supported Layer 2 service, VPLS and v-VPLS instances. The
following considerations apply:
3.11.7
Below are the steps for configuring a ring path:
1 Configure eth-ring
2 Configure one of the ring paths with a control VLAN i.e r-aps tag. (a free control
3 It is not allowed to make the path admin-up until an eth-cfm mep is configured for
4 Configure eth-cfm mep for the ring path.
5 Make the path admin-up.
6 Enabling of CCM on eth-ring MEP is optional (required for CCM based signal
Issue: 13

Duplex NT ERPS Performance considerations

Most Preferred Approach: Use Multi NT lags (lags having ports from both NT), to
prevent NT Switchover from triggering ERP Switch. Forwarding databases (L2
Table, Multicast FIB, ARP, etc.) are not affected.
Controlled Switchover case: Do a manual switchover of the ERPS path in the RPL
owner (incase of RPL owner is not ISAM) before administratively triggering NT
switchover in one of the NTs. This should be done to prevent extra outage during
NT switchover due to NT switchover delay, i.e. traffic is already switched to the
newly to-be Active NT before the NT switchover.

Support Service and Solution Combinations

Only ports in access or hybrid mode can be configured as eth-ring paths.
Dot1q ports are supported as eth-ring path members.
A mix of regular and multiple eth-ring SAPs and PWs can be configured in the
same services.

Configuration guide-lines

VLAN should be available, that is, no SAP should exist with control VLAN)
that path.
failure detection i.e for peers not connected directly).
3HH-11985-AAAA-TQZZA
Services Overview
69

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

73307360

Table of Contents