FD 100/320Gbps NT and FX NT IHub Services Guide
7.10.2.13
Table 423
7.10.2.14
Table 424
7.10.2.15
Table 425
(1 of 2)
Issue: 13
mtu
mtu command
Item
Description
Syntax
mtu mtu-bytes
no mtu
Context
configure>service>vprn>router-advertisement>interface
Description
This command configures the MTU for the nodes to use to send packets on the link.
Default
no mtu — The MTU option is not sent in the router advertisement messages.
Parameter
mtu-bytes — Specify the MTU for the nodes to use to send packets on the link.
Values: 1500 — 2026
other-stateful-configuration
other-stateful-configuration command
Item
Description
Syntax
[no] other-stateful-configuration
Context
configure>service>vprn>router-advertisement>interface
Description
This command sets the "Other configuration" flag. This flag indicates that DHCPv6lite is
available for autoconfiguration of other (non-address) information such as DNS-related
information or information on other servers in the network. See RFC 3736, Stateless Dynamic
Host Configuration Protocol (DHCP) for IPv6.
Default
no other-stateful-configuration
prefix
prefix command
Item
Description
Syntax
[no] prefix [ipv6-prefix/prefix-length]
Context
configure>service>vprn>router-advertisement>interface
Description
This command configures an IPv6 prefix in the router advertisement messages. To support
multiple IPv6 prefixes, use multiple prefix statements. No prefix is advertised until explicitly
configured using prefix statements.
Default
None
3HH-11985-AAAA-TQZZA
Virtual Private Routed Network Service
457