Node-Id; Rpl-Node; Table 36 Guard-Time Command; Table 37 Node-Id Command - Nokia 7302 Manual

Services Overview
Table 36
3.17.5.5
Table 37
3.17.5.6
Table 38
96
guard-time command
Item Description
Syntax guard-time time
Context configure>eth-ring
Description Configure the eth-ring guard time
Parameters time - eth-ring guard time in deciseconds
Values: 1...20
Default: 5

node-id

node-id command
Item Description
Syntax node-id xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx
Context configure>eth-ring
Description Configure the node ID of the Ethernet Ring
Parameters xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx - MAC address representing the node ID.

rpl-node

rpl-node command
Item Description
Syntax [no] rpl-node {owner}
Context configure>eth-ring
Description This command configures a node to act as a RPL owner in an Ethernet ring.
RPL Owner is the node connected to Ring Protection Link (RPL) that blocks traffic on RPL
during Idle state and unblocks during Protected state.
The no form of this command; removes the RPL owner functionality.
Parameters None
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13