FD 100/320Gbps NT and FX NT IHub Services Guide
4.6.4.8
Table 66
4.6.5
4.6.5.1
Table 67
(1 of 2)
Issue: 13
rate-limit
rate-limit command
Item
Description
Syntax
rate-limit cir cir-rate pir pir-rate [cbs cbs-size] [pbs pbs-size]
no rate-limit
Context
configure>service>epipe>egress
Description
This command defines the aggregate egress rate limit for the Epipe service. It applies to traffic
associated to the service which is egressing on regular ports (network ports).
The committed information rate and the peak information rate are specified. Optionally, the
committed burst size and the peak burst size may be entered. If these values are not specified,
they assume the default value of 256 Mbytes.
More information on rate-limting and some constraints regarding the granularity of the values
for rate and burst-size can be found in the "FD 100/320Gbps NT and FX NT IHub Qos Guide".
The no form of the command removes the rate limiting for the service.
Parameters
pir-rate — The pir parameter defines the administrative PIR rate, in kilobits, used for the
service. When the rate-limit command is executed, a valid PIR setting must be explicitly
defined.
Values: 0...100000000, max
cir-rate — The cir parameter defines the CIR rate, in kilobits, used for the service. When the
rate-limit command is executed, a valid CIR setting must be explicitly defined.
Values: 0...100000000, max
cbs-size — The cbs parameter defines the CBS size, in kilobytes, used for the service. When
the rate-limit command is executed, the cbs parameter can be optionally specified.
Values: 1...262144, default
pbs-size — The pbs parameter defines the PBS size, in kilobytes, used for the service. When
the rate-limit command is executed, the pbs parameter can be optionally specified.
Values: 1...262144, default
VLL SDP Commands
spoke-sdp
spoke-sdp command
Item
Description
Syntax
spoke-sdp sdp-id:vc-id [vc-type {ether | vlan}
Context
configure>service>epipe
3HH-11985-AAAA-TQZZA
Virtual Leased Line Services
133