Table 129 Endpoint Command; Table 130 Ignore-Standby-Signaling Command; Table 131 Revert-Time Command; Endpoint - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
5.16.2.6
Table 129
5.16.2.7
Table 130
5.16.2.8
Table 131
(1 of 2)
Issue: 13

endpoint

endpoint command
Item Description
Syntax endpoint endpoint-name [create]
no endpoint
Context configure>service>vpls
Description This command configures a service endpoint.
Parameter endpoint-name — Specifies an endpoint name, 32 chars maximum
ignore-standby-signaling
ignore-standby-signaling command
Item Description
Syntax [no] ignore-standby-signaling
Context configure>service>vpls>endpoint
Description When this command is enabled, the node will ignore standby-bit received from TLDP peers for
the given spoke SDP and performs internal tasks without taking it into account.
This command is present at endpoint level as well as spoke SDP level. If the spoke SDP is part
of the explicit-endpoint, it is not possible to change this setting at the spoke SDP level. The
existing spoke SDP will become part of the explicit-endpoint only if the setting is not conflicting.
The newly created spoke SDP which is a part of the given explicit-endpoint will inherit this
setting from the endpoint configuration.
Default disabled
revert-time
revert-time command
Item Description
Syntax revert-time {revert-time | infinite}
no revert-time
Context configure>service>vpls>endpoint
Description This command configures the time to wait before reverting to primary spoke SDP.
3HH-11985-AAAA-TQZZA
Virtual Private LAN Service
255