Configuring Ies Interface Parameters - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
6.7.2
The following example displays an IES configuration with interface parameters:
A:ALA-48>configure>service>ies>interface# info
----------------------------------------------
----------------------------------------------
A:ALA-48>configure>service>ies>interface#
6.7.3
A SAP is a combination of a port and encapsulation parameters which identifies the
service access point on the interface and within the router. Each SAP must be unique
within a router.
Filter policies are configured in the configure>filter context and must be explicitly
applied to a SAP. There are no default filter policies.
Refer to
This example displays an IES SAP configuration.
*A:ALA-A>configure>service>ies>interface# info
----------------------------------------------
----------------------------------------------
*A:ALA-A>configure>service>ies>interface#
6.8 Service Management Tasks
This section discusses the following service management tasks:
•
•
•
•
Issue: 13

Configuring IES Interface Parameters

address 10.1.1.1/24
sap nt:sfp:1:50 create
ingress
exit
egress
exit
exit
Configuring SAP Parameters
IES Services CLI Command Reference
address 10.10.36.2/24
sap lt:1/1/5:0 create
ingress
egress
exit
exit
Modifying IES Service Parameters
Deleting an IES Service
Disabling an IES Service
Re-enabling an IES Service
3HH-11985-AAAA-TQZZA
Internet Enhanced Service
for CLI syntax.
361