Table 194 Mode Command; Table 195 Mst-Instance Command; Mode - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
(2 of 2)
5.16.3.12
Table 194
5.16.3.13
Table 195
(1 of 2)
Issue: 13
Item Description
Description This commands specifies the port priority within a given instance, expressing probability that a
given port will be put into the forwarding state if a loop occurs.
The no form of this command sets port-priority to its default value.
Default 128
Parameters stp-priority — Specifies the value of the port priority field.
Values: 1 — 255

mode

mode command
Item Description
Syntax mode {rstp | comp-dot1w | dot1w | mstp | pmstp}
no mode
Context configure>service>vpls>stp
Description This command specifies the version of Spanning Tree Protocol the bridge is currently running.
See Spanning Tree Operating Modes
The no form of this command returns the STP variant to the default.
Default rstp
Parameters rstp — Corresponds to the Rapid Spanning Tree Protocol specified in IEEE 802.1D/D4-2003.
compdot1w — Corresponds to the Rapid Spanning Tree Protocol fully conform to IEEE
802.1w.
dot1w — Corresponds to the mode where the Rapid Spanning Tree is backward compatible
with IEEE 802.1w.
mstp — Sets MSTP as the STP mode of operation. Corresponds to the Multiple Spanning Tree
Protocol specified in 802.1Q REV/D5.0-09/2005.
pmstp — The PMSTP mode is only supported in VPLS services where the m-VPLS flag is
configured.
mst-instance
mst-instance command
Item Description
Syntax [no] mst-instance mst-inst-number
3HH-11985-AAAA-TQZZA
Virtual Private LAN Service
for details on these modes.
289