Table 372 Filter Command; Table 373 Egress Command; Filter - Nokia 7302 Manual

FD 100/320Gbps NT and FX NT IHub Services Guide
6.10.8.2
Table 372
6.10.8.3
Table 373
Issue: 13

filter

filter command
Item Description
Syntax filter { ip ip-filter-id| ipv6 ipv6-filter-id}
no filter [ip ip-filter-id] [ipv6 ipv6-filter-id]
Context configure>service>ies>interface>sap>egress
configure>service>ies>interface>sap>ingress
Description This command associates a filter policy with an ingress or egress Service Access Point (SAP).
Filter policies control the forwarding and dropping of packets based on the matching criteria.
The filter command is used to associate a filter policy with a specified ip-filter-id with an ingress
or egress SAP. The filter policy must already be defined before the filter command is
executed. If the filter policy does not exist, the operation will fail and an error message
returned.
In general, filters applied to SAPs (ingress or egress) apply to all packets on the SAP. One
exception is non-IP packets are not applied to the match criteria, so the default action in the
filter policy applies to these packets.
The no form of this command removes any configured filter ID association with the SAP. The
filter ID itself is not removed from the system unless the scope of the created filter is set to local.
To avoid deletion of the filter ID and only break the association with the service object, use
scope command within the filter definition to change the scope to local or global. The default
scope of a filter is local.
Special cases IES — Only IP filters are supported on an IES IP interface, and the filters only apply to routed
traffic.
Parameters ip — Keyword indicating the filter policy is an IP filter.
ip-filter-id — Specifies the ID for the IP filter policy. Allowed values are an integer in the range
of 1 and 65535 that corresponds to a previously created IP filter policy in the
configure>filter>ip-filter context.
ipv6 — Keyword indicating the filter policy is an IPv6 filter.
ipv6-filter-id — Specifies the ID for the IPv6 filter policy. Allowed values are an integer in the
range of 1 and 65535 that corresponds to a previously created IP filter policy in the
configure>filter>ipv6-filter context.
egress
egress command
Item Description
Syntax egress
Context configure>service>ies>interface>sap
Description This command enables the context to configure egress SAP filter policies.
If no egress filter is defined, no filtering is performed
3HH-11985-AAAA-TQZZA
Internet Enhanced Service
397