Table 356 Lease-Populate Command; Table 357 Option Command; Lease-Populate - Nokia 7302 Manual

Internet Enhanced Service
6.10.7.5
Table 356
6.10.7.6
Table 357
388

lease-populate

lease-populate command
Item Description
Syntax lease-populate [nbr-of-leases]
no lease-populate
Context configure>service>ies>interface>ipv6>dhcp6-relay
Description This command specifies specify the maximum number of leases maintained in the lease state
database. Lease populate is enabled by default. The operator can change the size of lease
table using this command. Lease populate can not be disabled. Once the maximum number
of entries has been reached, subsequent lease state entries are not allowed.
The no form of this command resets the lease table size to its default value.
Default Default size of the lease table is 8000.
Parameters nbr-of-leases — Defines the number lease state table entries allowed for this interface. Once
the maximum number of entries has been reached, subsequent lease state entries are not
allowed.
The system wide maximum number of leases allowed with all IP interfaces is 24576 including
IPv4 and IPv6 leases.
Values 1 — 8000
option
option command
Item Description
Syntax [no] option
Context configure>service>ies>interface>ipv6>dhcp6-relay
Description This command enables the configuration of the interface ID option and remote-id option for
DHCPv6 relay agent.
The no form of this command returns the system to the default.
Default no option
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13