Deleting Sdps; Modifying Lsps - Nokia 7302 Manual

Services Overview
Example:
configure>service# sdp 79
configure>service>sdp# description "Path-to-107"
configure>service>sdp# shutdown
configure>service>sdp# far-end "10.10.10.107"
configure>service>sdp# path-mtu 1503
configure>service>sdp# no shutdown
To match the incoming traffic's TPID with SDP, you can use vlan-vc-etype. the
following scenarios can occur:
•
•
Example:
configure>service# sdp 79
configure>service>sdp# vlan-vc-etype 0x88a8
3.8.4.4
The no form of the sdp command removes an SDP ID and all associated information.
Before an SDP can be deleted, the SDP must be shutdown and removed (unbound)
from all customer services where it is applied.
configure>service# no sdp 79
Example:
configure>service# epipe 5 spoke-sdp 79:5
configure>service>epipe>sdp# shutdown
configure>service>epipe>sdp# exit
configure>service>epipe# exit
configure>service# no sdp 79
3.8.4.5
For RSVP-based LSP refer to the FD 100/320Gbps NT and FX NT IHub MPLS
Guide. The syntax for static LSP is shown as a quick reference.
To display a list of static LSPs, use the show router mpls static-lsp command.
configure>router>mpls# static-lsp lsp-name
Example:
58
For traffic ingress on SDP, the dataplane traffic whose TPID (Ethertype after the
MPLS label) does not match with the vlan-vc-etype configured on the SDP, then
the traffic would be forwarded with extra VLAN tag, for example, the user tag
preserved and outer tag added with VLAN of egress SAP and TPID of service.
In case the ingress control plane traffic TPID does not match with the SDP TPID,
then it will be dropped.

Deleting SDPs

Modifying LSPs

3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13