Configuring The Sonet Controller - Cisco ASR 1000 Series Software Configuration Manual

Configuring SONET (OC-3)
PLIM Type: E1, TX clocking: LINE
Cell-payload scrambling: OFF
0 input, 0 output, 0 IN fast, 0 OUT fast
Avail bw = 1920
Config. is ACTIVE
Router#show atm interface ATM1/1/14.10
Interface ATM1/1/14.10:
AAL enabled:
Max. Datagram Size: 4528
PLIM Type: E1, TX clocking: LINE
Cell-payload scrambling: OFF
0 input, 0 output, 0 IN fast, 0 OUT fast
Avail bw = 1920
Config. is ACTIVE
Router# show atm pvc
Interface
1/1/14.10
Configuring SONET (OC-3)
Use the following guidelines to configure SONET (OC-3) on the1-Port Channelized OC-3 STM1 ATM CEoP
SPA:
• Each T1 can be configured to operate in the CEM mode.
• CEM groups can be directly configured on a T1.
• CEM groups can be channelized to DS0s.
• A maximum of 2016 DS0s can be configured.
• A maximum of 575 CEM circuits can be configured.

Configuring the SONET Controller

To configure the SONET controller, perform the following steps:
SUMMARY STEPS
1. Router(config)# controller sonet 0/1/0
2. Router(config-controller)# framing sonet
3. Router(config-controller)# sts-1 2
4. Router(config-ctrlr-sts1)# mode vt-15
5. Router(config-controller-stsl)# vtg 5 t1 1 cem-group 15 timeslots 1-5,20-23
6. Router(config-controller-sts1)# exit
DETAILED STEPS
Command or Action
Step 1 Router(config)# controller sonet 0/1/0
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide, Cisco IOS
XE Everest 16.5
514
AAL5, AAL0, Maximum VCs: 2047, Current VCCs: 1
VCD /
Name VPI VCI Type
1 10 11 PVC
Configuring the Circuit Emulation over Packet Shared Port Adapter
Peak Av/Min Burst
Encaps SC Kbps
SNAP UBR 1920
Purpose
Selects the controller to be configured.
Kbps Cells St
UP
OL-14127-17